Written by
Clara Bennett Appliance Care EditorPublished September 3, 2026Updated October 20, 2026
Content status:
Verified
Error codeRELAY 7 BROKEN
ApplianceBlast Chiller
Quick answer
The electronic board of a U-Line blast chiller detected a failure on relay 7. The manual says to call service.
Model compatibility: U-Line reuses codes across series and model years, so RELAY 7 BROKEN may mean something different on another appliance or generation. Confirm this against your model’s documentation and record your full model number before acting.
Plain language
What this code means
The electronic board detected a failure on relay 7; call service.
The display reads RELAY 7 BROKEN. In U-Line’s alarm list that means the board has found a failure on relay 7, and the listed response is to call service.
Because the fault sits on the electronic board, there is no owner step to carry out. You can look in the ALARM tab to confirm what was recorded, then call.
Also look at
RELAY 1 BROKEN: a different relay failure reported by the same board
RELAY 3 BROKEN: relay alarm that is easy to mix up with this one
U-Line blast chiller repair in Los Angeles
To book blast chiller repair in Los Angeles, ring (310) 879-5776. Provide the model number, the relay number shown and any earlier attempts. More at refrigerator repair.
Important safety warning. Do not attempt repairs involving electrical components, gas, water lines, refrigerant or sealed systems. Unplug the appliance if it is safe to reach the outlet, and leave internal diagnostics to a qualified technician.
Seeing this code on your U-Line appliance?
Book a specialist visit for a clear estimate and approval before any repair.
U-Line products are compact, built-in, and often visually similar across generations. Effective repair starts with the exact model, the symptom you can…
